Double pack extra fast drying clear coat, high gloss and hardness, easy application, suitable for fast
repairs of spots, low consumption and high efficiency to ensure good profit.

 

Substrates	1K basecoat
Surface Cleaning	Remove wax, silicon or other contaminations with degreaser.
Mixing Ratio	Item			Weight（Volume）
	MAX-7000 Extra Fast Clear Coat			100 parts
	MAX-3600 Extra Fast hardener			50 parts
	M-1 Thinner			0-5 parts
Pot Life	1 hours at 20℃
No. of Coats	2-3 coats, about 40um
Flash-off Time	30 seconds between coat; Because of fast surface drying, to spray without flash-off time is better for paint leveling. Allow 10 minutes air drying time before baking.
Spray Gun & Pressure	Gravity Feed　　  1.2-1.5mm　　    3-5kg/ cm2
Drying Time	Temperature	Tack Free	Dry to Handle		Polishing Time	Thorough Dry
	20℃	about 13 minutes	about 100 minutes		About 200 minutes	5 days
	70℃		10 minutes		15 minutes	60 minutes
Shelf Life	2 years in original sealed can at cool and dry place at 20℃.
Packaging	1L, 4L

 

Note：

1．After mixing clear coat with hardener, just add small quantity of M-1 thinner for spraying.
The mixture should be used up within 1 hour.

2．As this product dries very fast, the spray viscosity could not be too high, so that paint defects such as
orange skin, could be avoided.

3．Do not use at conditions of high temperature and high humidity, otherwise there will be
defects such as blistering or blushing. It is recommended to apply at conditions of
temperature lower than 25℃ and humidity lower than 80%. At temperature lower than
10℃, allow a forced dry by baking.

4．This product is suitable for small area repairs, large area or overall refinishing is not
recommended.

5．The above drying time is tested by Yatu technique Department and for reference only, the
drying effect would be a little different when the application environment and conditions
are different.

6．Clean equipments immediately with solvent after application.